A renowned automotive supplier from Germany has recently started using the AQON Hi' Tension System and the Hi' Pure Filter to improve the cleanliness of the coolant circulation during grinding of carbide materials. Previously, there were recurring quality issues caused by grinding comma, sediment fo…

The treatment of process or wastewater with conventional evaporator systems has so far been an expensive process, accompanied by long downtimes and frequent repairs. The distillate quality often needs to be reprocessed in conventional systems because a too high conductivity, BOD, or hydrocarbon cont…

Rising quality demands on surface quality and the increased use of multifunctional machine tools, e.g., with integrated grinding processes, lead to an ever-increasing load of fluid media with fine dirt or fine debris.

Conventional centrifuges or filter systems can only separate contaminants of 5 – 15…

The filtration or separation of fine contaminants – particularly particles 1 μm to 15 μm – rarely achieves sufficient results with conventional filter technology or centrifuges, as the physical size of these substances, their low weight (especially aluminum, etc.), and limited volume flows do not al…

Approximately 10% of all infections with multidrug-resistant hospital pathogens are caused solely in Germany by Pseudomonas aeruginosa – hundreds of which result in fatalities.

This pathogen is also found in climate, washing, and process engineering, as it occurs in biofilm and slime layers and has d…

Research Goal

Simplification of filtration (optimization of filter system performance), reduction of residual dirt load – higher purity – safe quality – lower fluid costs

Since early 2016, successful experiments at the Tool Laboratory (WZL) of RWTH Aachen have demonstrated the effect of pulsed high vo…

The treatment of old emulsions or oil-containing process waters is very complex and costly. The goal is to separate oily and volatile substances (hydrocarbons, etc.) as well as CSB-formers from the water and to produce as little waste as possible.

As an alternative to previously common methods, such…

An economical and quality-assuring process bath maintenance is essential to prevent residual dirt on surfaces and to minimize operating and disposal costs.

At a renowned, globally active metal processor with plants in Hesse, part cleaning was carried out until 2014 using a fully automatic multi-chamb…

HIGH CLEANLINESS / QUALITY WITH 50% COST REDUCTION

PRACTICE REPORT FROM THE METAL INDUSTRY

In now already 2 plants, a globally operating company in metal processing uses the AQON TENSID and CHEMIE – RECOVERY SYSTEM TCRS in combination with a high-performance filter in cleaning and degreasing processes…