Firstly, the question arises: why is monitoring necessary in a cleanroom at all? Quite simply: for example, incorrect differential pressure can lead to contamination. Continuous recording of data allows deviations to be detected immediately. Necessary measures to prevent damage to stored materials c…

The 1st VDI Conference "Quality Assurance and Contamination Control of Medical Devices" on November 5 and 6, 2012 in Nuremberg discusses the entire process chain of medical devices

How clean do medical devices actually need to be? The scandals about contaminated medical devices show that consequences…

Only precise knowledge of your compressed air and process gas costs allows for the identification of savings potential. The new thermal flow meters from E+E Elektronik measure the mass flow or standard volume flow in your supply network independently of pressure and temperature, with the highest acc…

AAF has developed a new dedicated website to showcase its new NELIOR Filtration Technology. The website demonstrates all air filtration solutions and explains the benefits that can be achieved. It also provides a brief introduction to the functionality and design of the new NELIOR Life Cycle Valuati…

Gerresheimer Medical Plastic Systems Dongguan Co. is an FDA-inspected Medical Device Manufacturer for the production of a new inhaler. As part of the product's drug approval process in the American market, the entire value chain was scrutinized under the strictest standards.

With the successful inspe…

• Unique membrane air filter medium with high collection efficiency, superior mechanical strength, chemical resistance, and up to 50% lower operating pressure difference

• New HEPA and ULPA filter technology tailored to the highest requirements of the pharmaceutical and microelectronics industries

At…

In recent weeks, Dutron employees have worked with great dedication to develop and install the new cleanroom. This summer, Dutron will commission its new cleanroom. The Dutron cleanroom of class 7, measured according to ISO 14644-1 standards, has been designed for sterile cable and wiring harness as…

ENGEL AUSTRIA has expanded its collaboration with Trexel (Wilmington/USA) and fully integrated the MuCell units into the injection molding machines of the ENGEL victory and ENGEL e-victory series. This has enabled the two partners to significantly improve the price/performance ratio of foam injectio…

PMT introduces an innovative concept with an open software structure and modular design through the FMSnode® system. Optimized for integration of cleanroom sensors, temperature monitoring in cooling units, and particle counters, the FMSnode® system is open to any conceivable sensor (TCP/IP Ethernet…

For Fakuma 2012, the babyplast product family presents energy-efficient solutions in 1K and 2K to increase the cost-effectiveness of injection molding small and micro parts. This time, the focus is on LSR components (Liquid Silicone Rubber), which can be used to upgrade or retrofit babyplast machine…