The VDI Technology Forum, taking place on September 10 and 11, 2013, in Mannheim, is equally interesting for the industries of automotive technology, optics, electrical engineering, and medical technology. Whether in the manufacturing of plastic components for polymer optics or electronics, vehicle…

The requirements for filling systems are constantly increasing. For example, when planning a facility for the production of human pharmaceuticals, special requirements and - depending on the product - legal regulations according to GMP must be considered. (Good Manufacturing Practice). Here, guideli…

Modern diesel engines and their injection systems are sensitive to contaminants and water in the fuel. Even microscopic particles can cause significant damage. Mann-Filter therefore offers fuel filters with high filtration precision and efficient water separation, reliably protecting all components…

NTTF Coatings GmbH has recently commissioned a new cleanroom. From now on, medical implants coated by the surface technology specialist can be directly packaged under sterile conditions immediately after coating. The company is based in the Rheinbreitbach Surface Technology Technology Center (TZO…

Sustainability, Reliability, and Quality – these are the strengths of Z-Laser, the provider of intelligent laser technology from Freiburg. By being flexible to meet individual customer wishes and having the courage to explore new paths, the Z-Laser team has achieved continuous growth and worldwide s…

The decision to install an industrial rapid-roller door is made by plant planners and architects for various reasons. Before replacing doors in existing buildings, WMF AG established several selection criteria. After careful examination of all parameters, the planners at the Geislingen headquarters…

Grinding and cleaning still remain the neglected areas in manufacturing. Despite this, a strong interest in efficient solutions for these tasks was evident at the fully booked 1st Conference on "Deburring and Cleaning" organized by fairXperts GmbH, which took place on July 3 and 4, 2013, in Nürtinge…

Imec today announced a cryogenic etching method that protects the surface of porous ultralow-k dielectrics against excessive plasma induced damages.

As semiconductor technology scales below the 20nm node, the capacitance increases between nearby conductive portions of high-density integrated circuits…

•    Juniális: Focus on cost-effective moulded part production
•    Around 80 guests gained detailed information on automation and energy requirement
•    Enhanced efficiency: Perfectly combining the Allrounder injection moulding machine and Multilift robotic system

On 27 and 28 June, the Arburg team presented…

In a cleanroom, air is the most important constant!

To ensure consistent product quality, it is essential to maintain the air pressure within the cleanroom cell at a constant level. Furthermore, it must be guaranteed that the introduced air meets the quality standards corresponding to the cleanroom c…